The Ubiquiti Wave-Pico is a 60 GHz point-to-multipoint (PtMP) client device with built-in 5GHz Wifi 6 (802.11ax) backup radio. Max link range when used with Wave-AP is 1.3 km or 0.9 km when used with Wave-AP-micro. The throughput of the device is 2 Gbps(1 Gbps duplex) and 5 GHz backup can reach up to 800 Mbps. Unit is euiped with 1 Gbps LAN port with PoE 48V DC support. To simplify setup, the device is equipped with integrated Bluetooth to connect to the UISP mobile app or there is an option to setup via web interface.

Key features:
• Range up to 1.3 km when using Wave AP
• Power supply via PoE
• Throughput in the 60 GHz band 2000 Mbps, in the 5 GHz band up to 800 Mbps
• Integrated Bluetooth for setup via the UISP mobile app

* Distance depends on total radiated power, which may vary from country to country

Before putting the link into operation, it must first be registered on the 60ghz.ctu.cz portal in accordance with VO-R/12.

Package contents:
• Device
• Device holder for 20 to 53 mm diameter loops
• Gigabit adapter 48V DC 0.5A
• QuickStart

Caution! According to current Greek Legislation, of N.F.B.A.R. and the provisions of the P.D. 98/2017 the lawful use of this product in the frequency band 5470 – 5725MHz, provides for a maximum transmit power of 100mW e.i.r.p.
At this maximum power the output power of the transmitter and the gain of the antenna are both taken into account. Responsible for spectrum surveillance is H.T.P.C.
This product is CE marked, P.D. 98/2017
This product is intended for indoor use.

Warranties - Returns:
Money Return:	Repair - Replacement:
20 days	24 months

Mechanical
Dimensions	Ø152.1 x 55.8 mm
Weight	Without mount: 347 g With mount: 409 kg
Enclosure materials	UV stabilized plastic polycarbonate
Mount material	UV stabilized plastic polycarbonate
Pole mount diameter	20 to 53.1 mm on pipe outer diameter
Wind loading	31.3 N at 200 km/h
Weatherproong	IPX6
Hardware
Processor	Dual-core ARM® Cortex® -A53 cores at 1GHz
Memory	DDR3L 512MB
Networking interface	(1) GbE RJ45 port
Max. power consumption	10W
Power method	Passive PoE 4-pairs (1, 2+; 3, 6-) (4, 5+; 7, 8 -) Passive PoE 2-pairs (4, 5+; 7, 8 -), for 44–54V DC only
Power supply	48V DC, 0.5A gigabit PoE adapter (Included) Can be powered by a UISP Router or UISP Switch
Supported voltage range	44–54V DC 22–27V DC
Button	Factory reset
LEDs	Power, Ethernet, Link
Operating temperature	-40 to 60° C
Operating humidity	5 to 95% noncondensing
Certications	FCC, IC, CE
Software
Operating mode	PtMP station, PtP
Ubiquiti specic features	Wave AI, discovery protocol
Services	UISP, ping watchdog, NTP client, SNMP
Tools	Antenna alignment, discovery utility, ping, trace route, speed test
Network	Bridge/Router* mode *Router is available in PtMP station mode only.
Application requirements	UISP web: Version 2.4.61 and later UISP mobile iOS™: Version 2.32.0 and later UISP mobile Android™: Version 2.31.9 and later
System
Total throughput	2 Gbps (1 Gbps duplex)
Maximum range	Up to 1.3 km (Wave AP) Up to 0.9 km (Wave AP Micro)
Encryption	WPA2-PSK (AES)
RF
Operating frequency*	57 to 71 GHz *Depends onregulatory region
GPS	Yes
Channel bandwidth	2160, 1080 MHz
Operating channels*	58320, 59400, 60480, 61560, 62640, 63720, 64800, 65880, 66960, 68040, 69120, 70200 MHz *Depends onregulatory region
Modulation	16QAM, QPSK
Polarization	Vertically linear
Beamwidth	Azimuth: 3 dB 6° Elevation: 3 dB 6°
Back-Up RF
WiFi standard	802.11ax (WiFi 6)
Operating frequency*	US/CA U-NII-1 5150 - 5250 MHz U-NII-2A 5250 - 5350 MHz U-NII-2C 5470 - 5725 MHz U-NII-3 5725 - 5850 MHz *Depends onregulatory region
Worldwide	5180 - 5875 MHz *Depends on regulatory region.
Channel bandwidth	20, 40, 80 MHz
Modulation	BPSK (1⁄2), QPSK (1⁄2), QPSK (3⁄4), 16QAM (1⁄2), 16QAM (3⁄4), 64QAM (2⁄3), 64QAM (3⁄4), 64QAM (5⁄6), 256QAM (3⁄4), 256QAM (5⁄6), 1024QAM (3⁄4), 1024QAM (5⁄6)
Antenna gain	9 dBi
Polarization	Dual-linear
Cross-pol isolation	15 dB
Beamwidth	Azimuth: 3 dB 50° Elevation: 3 dB 50°
LEDs
Power	Flashing white: bootup in progress White: not connected to UISP application Blue: connected to UISP application Flashing blue: locate in progress Blue/white: firmware upgrade in progress
Ethernet	Flashing Blue: Ethernet traffic detected
Links	White: 5GHz link Blue: 60GHz link